DTC Confirmation Procedure
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start engine and warm it up to normal operating temperature.
- Drive the vehicle for at least 5 seconds under the following conditions:CAUTION: Always drive vehicle at a safe speed.
Selector lever
Suitable position
Vehicle speed
40 km/h (25 MPH) or more
NOTE:- The gear must be fixed while driving the vehicle.
- Keep the accelerator pedal as steady as possible during cruising.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES
Proceed to DTC Diagnosis Procedure .
NO
INSPECTION END