Component Inspection

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CRANKSHAFT POSITION SENSOR (POS)-1

Turn ignition switch OFF.
Loosen the fixing bolt of the sensor.
Disconnect crankshaft position sensor (POS) harness connector.
Remove the sensor.

Visually check the sensor for chipping.

Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES

GO TO 2.

Replace crankshaft position sensor (POS). Refer to Component Parts Location .

CHECK CRANKSHAFT POSITION SENSOR (POS)-2

Check the resistance between crankshaft position sensor (POS) terminals as per the following.

Courtesy of NISSAN NORTH AMERICA, INC.

Crankshaft position sensor (POS)		Resistance [at 25 deg.C (77 deg.F)]
+	-
Terminal (Polarity)
1	2	Except 0 or INF.Ohm
	3
2	3

Is the inspection result normal?

YES

INSPECTION END

Replace crankshaft position sensor (POS). Refer to Component Parts Location .