LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 501 (Engine Control System (DTC/Circuit Diagnosis) (2 Of 3)) >> DTC/Circuit Diagnosis >> DTC P0315: Crankshaft Position >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC PRIORITY 

    If DTC P0315 is displayed with DTC P0335, first perform the trouble diagnosis for DTC P0335.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable. DTC Index

    NO

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start the engine and warm it up to normal operating temperature.
    2. Drive vehicle at 80 km/h, with selecting suitable gear.
      NOTE: Always keep safe driving to the first priority.
    3. Release accelerator pedal completely to decelerate the vehicle.
      NOTE: Always keep safe driving to the first priority.
    4. Repeat the step 2 and 3 until the integrated deceleration time to be 30 seconds.
    5. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Proceed to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals