LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 500 (Automatic Transmission (Re7R01B) (1 Of 2)) >> Basic Inspection >> Calibration Of DECEL G Sensor >> Work Procedure

Work Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: After removing/replacing the yaw rate/side/decal G sensor or replacing the ABS actuator and electric unit (control unit), the decel G sensor of the ABS actuator and electric unit (control unit) must be calibrated first. Refer to Description .
  1. PREPARATION BEFORE CALIBRATION PROCEDURE 
    1. Park the vehicle on a flat road.
    2. Adjust pressure in all tires to the specified value. Refer to Tire .

    GO TO 2.

  2. PERFORM CALIBRATION 

    SYMBOL With CONSULT

    1. Turn ignition switch ON.
      CAUTION: Never start the engine.
    2. Select "G SENSOR CALIBRATION" in "Work Support" in "TRANSMISSION".
    3. Touch "START".
      CAUTION: Never give any motion to the vehicle during the calibration.

    Is "completed" displayed?

    YES

    GO TO 3.

    NO

    Perform the calibration again.

  3. CHECK DTC 

    SYMBOL With CONSULT

    1. Turn ignition switch OFF and wait 10 seconds or more.
    2. Turn ignition switch ON.
    3. Select "Self Diagnostic Results" in "ABS".

    Is "C1145" or "C1146" detected?

    YES

    Refer to DTC Index .

    NO

    WORK END

scientia non olet · About LEMON Manuals