Diagnosis Procedure

Detects trunk open/close condition.

1. CHECK TRUNK LAMP SWITCH INPUT SIGNAL 
   1. Turn ignition switch OFF.
   2. Check voltage between BCM connector and ground.

      Terminal			Trunk condition	Voltage (V) (Approx.)
      (+)		(-)
      BCM connector	Terminal
      M19	97	Ground	OPEN	0
      			CLOSE	Courtesy of NISSAN NORTH AMERICA, INC.

   Is the inspection result normal?

   YES

   GO TO 6 .

   NO

   GO TO 2 .

2. CHECK TRUNK LAMP SWITCH CIRCUIT 
   1. Disconnect BCM and trunk lamp switch and trunk release solenoid connectors.
   2. Check continuity between BCM connector and trunk lamp switch and trunk release solenoid assembly connector.

      BCM connector	Terminal	Trunk lamp switch and trunk release solenoid assembly connector	Terminal	Continuity
      M19	97	B43	1	Yes

   3. Check continuity between BCM connector and ground.

      BCM connector	Terminal	Ground	Continuity
      M19	97		No

   Is the inspection result normal?

   YES

   GO TO 3 .

   NO

   Repair or replace harness between BCM and trunk lamp switch and trunk release solenoid assembly.

3. CHECK TRUNK LAMP SWITCH GROUND CIRCUIT 

   Check continuity between trunk lamp switch and trunk release solenoid assembly connector and ground.

   Trunk lamp switch and trunk release solenoid assembly connector	Terminal	Ground	Continuity
   B43	2		Yes

   Is the inspection result normal?

   YES

   GO TO 4 .

   NO

   Repair or replace trunk lamp switch and trunk release solenoid assembly ground circuit.

4. CHECK BCM OUTPUT SIGNAL 
   1. Insure trunk remains closed during this step.
   2. Connect BCM connector.
   3. Check voltage between BCM connector and ground.

      Terminals			Voltage (V) (Approx.)
      (+)		(-)
      BCM connector	Terminal
      M19	97	Ground	Courtesy of NISSAN NORTH AMERICA, INC.

   Is the inspection result normal?

   YES

   GO TO 5 .

   NO

   Replace BCM. Refer to Removal and Installation .

5. CHECK TRUNK LAMP SWITCH 

   Refer to Component Inspection .

   Is the inspection result normal?

   YES

   GO TO 6 .

   NO

   Replace trunk lamp switch and trunk release solenoid assembly.

6. CHECK INTERMITTENT INCIDENT 

   Refer to Intermittent Incident .

   Inspection End.