Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check signal between BCM harness connector and ground using oscilloscope.

   (+)		(-)	Condition		Signal (Reference value)
   BCM
   Connector	Terminals
   M19	102, 101	Ground	When the trunk opener request switch is operated with ignition switch OFF.	When Intelligent Key is in the antenna detection area.	Courtesy of NISSAN NORTH AMERICA, INC.
   				When Intelligent Key is not in the antenna detection area.	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES

Replace BCM. Refer to Removal and Installation .

NO

GO TO 2 .

1. Disconnect BCM connector and outside key antenna (rear bumper) connector.
2. Check continuity between BCM harness connector and outside key antenna (rear bumper) harness connector.

   BCM		Outside key antenna (rear bumper)		Continuity
   Connector	Terminal	Connector	Terminal
   M19	102	B46	1	Yes
   	101		2

3. Check continuity between BCM harness connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   M19	102		No
   	101

Is the inspection result normal?

YES

GO TO 3 .

NO

Repair or replace harness.

1. Replace outside key antenna (rear bumper). (New antenna or other antenna)
2. Connect BCM and outside key antenna (rear bumper) connector.
3. Check signal between BCM harness connector and ground using oscilloscope.

   (+)		(-)	Condition		Signal (Reference value)
   BCM
   Connector	Terminals
   M19	102, 101	Ground	When the trunk opener request switch is operated with ignition switch OFF.	When Intelligent Key is in the antenna detection area.	Courtesy of NISSAN NORTH AMERICA, INC.
   				When Intelligent Key is not in the antenna detection area.	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES

Replace outside key antenna (rear bumper). Refer to Removal and Installation .

NO

Replace BCM. Refer to Removal and Installation .