LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Engine Control System (VK56VD) DTC/Circuit Diagnosis (3 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0331: Knock Sensor >> DTC Diagnosis Procedure

DTC Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC PRIORITY 

    If DTC P0331 is displayed with DTC P0332 or P0333, first perform the confirmation procedure (trouble diagnosis) for DTC P0332 or P0333.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable. Refer to DTC Index .

    NO

    GO TO 2.

  2. CHECK INSTALLATION CONDITION OF KNOCK SENSOR 

    Visually check that the knock sensor is installed normally.

    Is the inspection result normal?

    YES

    GO TO 3.

    NO

    Repair or replace error-detected parts.

  3. CHECK INTERMITTENT INCIDENT 

    Check intermittent incident. Refer to Intermittent Incident .

    Is the inspection result normal?

    YES

    GO TO 4.

    NO

    Repair or replace error-detected parts.

  4. CHECK KNOCK SENSOR CIRCUIT 

    Check knock sensor circuit. Refer to DTC Diagnosis Procedure .

    Is the inspection result normal?

    YES

    GO TO 5.

    NO

    Repair or replace error-detected parts.

  5. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON.
    2. Erase DTC.
    3. Perform DTC confirmation procedure. Refer to DTC Confirmation Procedure .

    Is the 1st trip DTC P0331 displayed again?

    YES

    Replace ECM. Refer to Removal and Installation .

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals