Component Inspection (Exhaust Valve Timing Control Position
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- EXHAUST VALVE TIMING CONTROL POSITION SENSOR-I
- Turn ignition switch OFF.
- Disconnect exhaust valve timing control position sensor harness connector.
- Loosen the fixing bolt of the sensor.
- Remove the sensor. Refer to Exploded View .
- Visually check the sensor for chipping.
Is the inspection result normal?
YES
GO TO 2.
NO
Replace malfunctioning exhaust valve timing control position sensor. Refer to Exploded View .
- EXHAUST VALVE TIMING CONTROL POSITION SENSOR-II
Check resistance exhaust valve timing control position sensor terminals as shown below.
Terminals
Resistance
1 (+) - 2 (-)
Except 0 or INF.Ohm [at 25 deg.C (77 deg.F)]
1 (+) - 3 (-)
2 (+) - 3 (-)
Is the inspection result normal?
YES
INSPECTION END
NO
Replace malfunctioning exhaust valve timing control position sensor. Refer to Exploded View .