Component Inspection (Power Steering Pressure Sensor)
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK POWER STEERING PRESSURE SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Start engine and let it idle.
- Check the voltage between ECM harness connector terminals under the following conditions.
ECM
Condition
Voltage (V)
Connector
+
-
Terminal
Terminal
F78
24
13
Steering wheel
Being turned
0.5 - 4.5
Not being turned
0.4 - 0.8
Is the inspection result normal?
YES
INSPECTION END
NO
Replace power steering pressure sensor.