LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 490 (Engine Control System (VK56VD) DTC/Circuit Diagnosis (5 Of 6)) >> DTC/Circuit Diagnosis >> DTC P1220: Fuel Pump Control Module (FPCM) >> Component Inspection (FPCM)

Component Inspection (FPCM)

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUEL PUMP CONTROL MODULE (FPCM) 
    1. Check the voltage between FPCM terminals under the following conditions.

      FPCM

      Condition

      Voltage

      Connector

      +

      -

      Terminal

      Terminal

      C12

      6

      5

      For 1 second after turning ignition switch ON

      Approx. 8.5 V

      More than 1 second after turning ignition switch ON

      Approx. 0 V

      Idle speed

      Approx. 8.5 V

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace FPCM.