Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
  - Harness connector B1
  - Harness connector M6
  - Harness connector M1
  - Harness connector E30
  - Harness connector E2
  - Harness connector E202
Is the inspection result normal?

YES

GO TO 2 .

NO

Repair the terminal and connector.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Disconnect the connector of side radar LH.

Check the continuity between the harness connector and the side radar LH harness connector.

Side radar LH harness connector		Harness connector		Continuity
Connector No.	Terminal No.	Connector No.	Terminal No.
B77	6	B1	38J	Existed
	7		37J	Existed

Is the inspection result normal?

YES

GO TO 3 .

Repair the main line between the harness connector B1 and the side radar LH.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Disconnect the harness connector B1 and M6.

Check the continuity between the harness connectors.

Harness connector		Harness connector		Continuity
Connector No.	Terminal No.	Connector No.	Terminal No.
M6	38J	M1	58G	Existed
	37J		59G	Existed

Is the inspection result normal?

YES

GO TO 4 .

Repair the main line between the harness connector M6 and M1.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Disconnect the harness connector M1 and E30.

Check the continuity between the harness connectors.

Harness connector		Harness connector		Continuity
Connector No.	Terminal No.	Connector No.	Terminal No.
E30	58G	E2	21	Existed
	59G		20	Existed

Is the inspection result normal?

YES

GO TO 5 .

Repair the main line between the harness connector E30 and E2.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Disconnect the harness connector E2 and E202.

Check the continuity between the harness connectors.

Harness connector			Continuity
Connector No.	Terminal No.	Terminal No.	Continuity
E202	21	23	Existed
E202	20	22	Existed

Is the inspection result normal?

YES

Check CAN system type decision again.

YES

Error was detected in the main line between the side radar LH and the ICC sensor.

Repair the main line between the harness connector E202 and the ICC sensor.