Diagnosis Procedure
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONNECTOR
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
- Harness connector M6
- Harness connector B1
Is the inspection result normal?
YES
GO TO 2 .
NO
Repair the terminal and connector.
- CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
- Disconnect the following harness connectors.
- A/C auto amp.
- Harness connectors M6 and B1
- Check the continuity between the A/C auto amp. harness connector and the harness connector.
A/C auto amp. harness connector
Harness connector
Continuity
Connector No.
Terminal No.
Connector No.
Terminal No.
M37
1
M6
54J
Existed
21
52J
Existed
Is the inspection result normal?
YES
GO TO 3 .
NO
Repair the main line between the A/C auto amp. and the harness connector M6.
- Disconnect the following harness connectors.
- CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
Check the continuity between the harness connector terminals.
Harness connector
Continuity
Connector No.
Terminal No.
B1
54J
53J
Existed
52J
51J
Existed
Is the inspection result normal?
YES
Check CAN system type decision again.
YES
Error was detected in the main line between the A/C auto amp. and the ADAS control unit.
NO
Repair the main line between the harness connector B1 and the ADAS control unit.