LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 488 (Engine Mechanical (5.6L)) >> Removal And Installation >> VVEL Actuator Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect VVEL actuator motor assembly harness connector.
  2. Loosen bolts (C) and then remove VVEL actuator motor assembly (1).
    GNSJPBIA3487Z-487Courtesy of NISSAN NORTH AMERICA, INC.

    (A)

    : Bank 2

    (B)

    : Bank 1

    SYMBOL

    : Engine front
    CAUTION: Do not loosen screws (A) of VVEL actuator motor assembly.
    GNSJPBIA3866Z-866Courtesy of NISSAN NORTH AMERICA, INC.
  3. If removing the VVEL actuator housing assembly, use the following procedure:
    1. Remove rocker cover. Refer to Exploded View .
    2. Insert bolt (A) removed in step 2 into VVEL actuator housing assembly.
      GNSJSBIA0529Z-529Courtesy of NISSAN NORTH AMERICA, INC.
    3. Loosen bolt (C) to disengage the control shaft and the actuator arm.
      GNSJPBIA3498Z-498Courtesy of NISSAN NORTH AMERICA, INC.

      A.

      Bank 1

      B.

      Bank 2

      SYMBOL

      Engine front
    4. Loosen bolts (C) and then remove VVEL actuator housing assembly.
      GNSJPBIA3499Z-499Courtesy of NISSAN NORTH AMERICA, INC.

      1.

      VVEL actuator housing assembly (bank 1)

      2.

      VVEL actuator housing assembly (bank 2)

      A.

      Bank 1

      B.

      Bank 2

      SYMBOL

      Engine front
scientia non olet · About LEMON Manuals