Replacement Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Removal

Turning the base line (B) upwards, insert oil jet [bank 2 (1)] into Tool (A).

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- There is no base line before service part is setup. (Base line is applied from service part.)
- Set Tool so that position matches ground-side (D) and flat side (C) shown in the figure.
Tool number (A)

:--(J-51269-1)

: Front
Press tool inner (A) into tool outer (B) until it bottoms out and tighten bolts (C).

Courtesy of NISSAN NORTH AMERICA, INC.

: Front
Hand tighten nut (D).
Hold Tool (A) with a suitable tool (B) and tighten nut to remove oil-jet (bank 2).

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Beware of enlarging the hole diameter caused by tilting the Tool.

Tool number (A)

:--(J-51269-1)

: Front

Confirm the Hole Diameter

After removing oil jet (bank 2), use Tool (A) to confirm the hole diameter.

Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: If Tool is inserted deeper than 3 mm (0.118 in), replace cylinder block and oil-jet.

Tool number (A)

:--(J-51269-1)

: Front

Installation

Insert new oil jet [bank 2 (1)] into Tool (A) in the direction shown by arrow.

Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: When inserting new oil jet [bank 2 (1)], be sure that D-cut (B) surface on oil jet and the location plate (C) are parallel to each other.

Tool number (A)

:--(J-51269-2)
Hand tighten bolts (A).

Courtesy of NISSAN NORTH AMERICA, INC.
Hand tighten bolt (B) until you feel the pressure from oil jet (bank 2). Then tighten the bolt two rotations with a suitable tool and center the oil jet (bank 2) and the hole.
CAUTION: Do not tighten completely until the end of process.
Tighten bolts (A).
NOTE: Make Tool and oil jet (bank 2) are concentric.

Tool number

:--(J-51269-2)

: Front
Install oil jet (bank 2) by tightening bolt (B) until it stops.
Loosen bolts (A) and remove Tool from cylinder block.

Tool number

:--(J-51269-2)
Confirm the positional limitation of adjustment notch (A) on oil jet [bank 2 (1)] is within +/-10 deg. (b).

Courtesy of NISSAN NORTH AMERICA, INC.

If there is a gap (C) between oil jet [bank 2 (1)] and cylinder block (2) surface, repeat the steps 2 to 6 again.

Courtesy of NISSAN NORTH AMERICA, INC.

(A)	: OK
(B)	: NG