Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Remove the following parts:
- Drive belt: Refer to Removal and Installation .
- Cooling fan: Refer to Removal and Installation (Crankshaft driven type) .

Remove crankshaft pulley as per the following:

Remove rear plate cover. Refer to Exploded View .

Set Tool (A) as shown in the figure.

Courtesy of NISSAN NORTH AMERICA, INC.

Tool number (A)

: KV10120100 (J-47245)

Loosen crankshaft pulley bolt, and then pull crankshaft pulley with both hands to remove it.
CAUTION: Do not remove crankshaft pulley bolt. Keep loosened crankshaft pulley bolt in place to protect removed crankshaft pulley from dropping.

Remove front oil seal using a suitable tool.

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- Do not reuse front oil seal.
- Be careful not to damage front cover and crankshaft.