Removal and Installation: Installation

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Install rear oil seal.

CAUTION: Do not reuse rear oil seal.

Install rear oil seal so that each seal lip is oriented as shown in the figure.

Courtesy of NISSAN NORTH AMERICA, INC.

(A)	: Oil seal lip
(B)	: Dust seal lip
	: Engine inside
	: Engine outside

Press in rear oil seal (1) to the position as shown in the figure.

Courtesy of NISSAN NORTH AMERICA, INC.

(B)	: Rear oil seal retainer rear end face
(A)	: 0 - 0.5 mm (0 - 0.020 in)

Using a suitable drift, press-fit until the height of rear oil seal is level with the mounting surface.

Courtesy of NISSAN NORTH AMERICA, INC.

Check the garter spring is in position and seal lips are not inverted.
CAUTION:
- Be careful not to damage crankshaft and cylinder block.
- Press-fit straight and avoid causing burrs or tilting oil seal.

Installation of the remaining components is in the reverse order of removal.