Removal and Installation: Installation

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION: Do not reuse intake manifold gaskets.

Intake Manifold

Tighten intake manifold bolts in order as shown.

Fig 1: Intake Manifold Bolt Tightening Sequence

Courtesy of NISSAN NORTH AMERICA, INC.

Intake manifold bolts

: 11.0 N.m (1.1 kg-m, 8 ft-lb)

: Engine front

Electric Throttle Control Actuator

Tighten electronic throttle control actuator bolts in order as shown.

Fig 2: Electronic Throttle Control Actuator Bolts Tightening Sequence

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Do not reuse electric throttle control actuator gasket.

NOTE: The figure shows the electric throttle control actuator viewed from the air duct side.

Electronic throttle control actuator bolts

: 10 N.m (1.0 kg-m, 7 ft-lb)