LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 488 (Engine Mechanical (5.6L)) >> Removal And Installation >> Drive Plate >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install pilot converter to the crankshaft using suitable tool, if removed.
    G04073390Courtesy of NISSAN NORTH AMERICA, INC.
    • With a drift of the following outer diameter, press-fit as far as it will go.

      Pilot converter

      : Approx. 35 mm (1.38 in)
    • Press-fit pilot converter with its chamfering side facing crankshafts shown in the figure.
      GNSJPBIA0210Z-210Courtesy of NISSAN NORTH AMERICA, INC.

      SYMBOL

      : Crankshaft side
  2. Install drive plate in the reverse order of removal.
    • Install drive plate (4) and reinforcement plate (3) as shown in the figure.
      GNSJPBIA2275Z-275Courtesy of NISSAN NORTH AMERICA, INC.

      (2)

      : Pilot converter

      (A)

      : Rounded

      SYMBOL

      : Engine front
    • When installing drive plate to crankshaft (1), be sure to correctly align crankshaft side dowel pin and drive plate side dowel pin hole.
      CAUTION: If these are not aligned correctly, engine runs roughly and "MIL" illuminates.
    • Holding ring gear with Tool.

      Tool number

      : KV10120100 (J-47245)
    • Tighten the bolts crosswise over several times.
  3. Installation of the remaining components is in the reverse order of removal.
scientia non olet · About LEMON Manuals