DTC Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect multi-way control valve harness connector.
3. Turn ignition switch ON.
4. Check the voltage between multi-way control valve harness connector and ground.

   +		-	Voltage (Approx.)
   Multi-way control valve
   Connector	Terminal
   F92	5	Ground	5 V

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 2.

Perform Diagnosis Procedure .

Is inspection result normal?

YES

Perform the trouble diagnosis for power supply circuit. Refer to DTC Diagnosis Procedure .

NO

Repair or replace error-detected parts.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between multi-way control valve harness connector and ECM harness connector.

   +		-		Continuity
   Multi-way control valve		ECM
   Connector	Terminal	Connector	Terminal
   F92	3	F78	43	Existed

4. Also check harness for short to power.

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace error-detected parts.

1. Check the continuity between multi-way control valve harness connector and ECM harness connector.

   +		-		Continuity
   Multi-way control valve		ECM
   Connector	Terminal	Connector	Terminal
   F92	4	F79	61	Existed

2. Also check harness for short to ground and to power.

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace error-detected parts.

Check the multi-way control valve position sensor. Refer to Component Inspection (Multi-way Control Valve) .

Is the inspection result normal?

YES

INSPECTION END

NO

Replace multi-way control valve. Refer to Removal and Installation .