Component Function Check
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK BRAKE PEDAL POSITION SWITCH FUNCTION
WITH CONSULT
- Turn ignition switch ON.
- Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT.
- Check "BRAKE SW1" indication under the following conditions.
Monitor item
Condition
Indication
BRAKE SW1
(Brake pedal position switch)
Brake pedal
Slightly depressed
OFF
Fully released
ON
WITHOUT CONSULT
- Turn ignition switch ON.
- Check the voltage between ECM harness connector terminals as per the following.
ECM
Condition
Voltage (V)
Connector
+
-
Terminal
Terminal
E77
140
(Brake pedal position switch signal)
152
Brake pedal
Slightly depressed
Approx. 0
Fully released
Battery voltage
Is the inspection result normal?
YES
INSPECTION END
NO
Go to Diagnosis Procedure .