LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Chassis Control System) >> Chassis Control >> DTC/Circuit Diagnosis >> C1BA5-00 ADAS/Chassis Control Engine System >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ADAS CONTROL UNIT SYSTEM 

    SYMBOL CONSULT

    Select "Self diagnostic result" mode of "ECM".

    Is DTC detected?

    YES

    Check the DTC. Refer to DTC Index .

    NO

    GO TO 2 .

  2. PERFORM SELF-DIAGNOSIS 

    SYMBOL CONSULT

    1. Erase "Self diagnostic result" mode of "CHASSIS CONTROL".
    2. Turn the ignition switch OFF and wait for 10 seconds or more.
    3. Turn the ignition switch ON.
    4. Select "All DTC Reading" mode.

    Is DTC "C1BA5-00", "U1000-00" or other DTC detected?

    YES

    Replace the chassis control module. Refer to Removal and Installation .

    YES

    Refer to Diagnosis Procedure .

    YES

    Check the DTC.

    NO

    Inspection End.

scientia non olet · About LEMON Manuals