LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 479 (Wheel & Tire System) >> Basic Inspection >> Id Registration >> Work Procedure >> TPMS Registration With Consult Only

TPMS Registration With Consult Only

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

SYMBOL With CONSULT

  1. Adjust the tire pressure for all wheels to match the list below.

    Tire position

    Tire pressure kPa (kg/cm 2 , psi)

    Front LH

    240 (2.4, 35)

    Front RH

    220 (2.2, 32)

    Rear RH

    200 (2.0, 29)

    Rear LH

    180 (1.8, 26)

  2. Turn the ignition switch ON.
  3. Using CONSULT, select "Work support" in AIR PRESSURE MONITOR. Then, select "ID REGIST."
  4. Select "Start" on "ID REGIST" screen.
  5. Drive the vehicle at a speed greater than 40 km/h (25 MPH) for 3 minutes or more.
  6. After ID registration for all wheels is complete, press "End" on the CONSULT to finish ID registration.

    ID registration position

    CONSULT

    Front LH

    "Yet (red)"

    "Done (green)"

    Front RH

    Rear RH

    Rear LH

  7. Adjust the tire pressures for all tires to the recommended value. Refer to Tire .
  8. Test drive the vehicle to ensure that the TPMS lamp is OFF and no warning messages are present.