LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 477 (Brake Control System (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC C1145: Yaw Rate/Side/DECEL G Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO 2.

  2. CHECK DTC DETECTION 

    SYMBOL CONSULT

    1. Turn the ignition switch OFF.
      NOTE: Wait at least 10 seconds after turning ignition switch OFF.
    2. Start the engine.
      NOTE: Wait at least 10 seconds after starting the engine.
    3. Perform "Self Diagnostic Result" mode of "ABS".

    Is DTC "C1145" or "C1146" detected?

    YES

    "C1145" or "C1146" is displayed as "CRNT": Proceed to DTC Diagnosis Procedure .

    YES

    "C1145" or "C1146" is displayed as "PAST": Inspection End (Erase "Self Diagnostic Result" mode of "ABS").

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: Inspection End.

scientia non olet · About LEMON Manuals