Component Function Check

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

INSPECTION START
Turn ignition switch OFF, and restart engine.

Does the engine start?

YES

GO TO 2.

NO

Proceed to DTC Diagnosis Procedure .

IGNITION SIGNAL FUNCTION

With CONSULT

Perform "POWER BALANCE" in "ACTIVE TEST" mode of "ENGINE" using CONSULT.
Check that each circuit produces a momentary engine speed drop.

Without CONSULT

Let engine idle.

Check the voltage signal between ECM harness connector and ground with an oscilloscope.

ECM				Voltage signal
+		-
Connector	Terminal	Connector	Terminal
F77	103	E16	128	Courtesy of NISSAN NORTH AMERICA, INC.
	106
	113
	104
	107
	114

NOTE: The pulse cycle changes depending on rpm at idle.

Is the inspection result normal?

YES

INSPECTION END

Proceed to DTC Diagnosis Procedure .