Component Inspection
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ACCELERATOR PEDAL POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check the voltage ECM harness connector terminals as per the following.
ECM
Condition
Voltage (V)
+
-
Connector
Terminal
Terminal
E16
150
151
Accelerator pedal
Fully released
0.65 - 0.87
Fully depressed
More than 4.3
143
144
Fully released
0.28 - 0.48
Fully depressed
More than 2.0
Is the inspection result normal?
YES
INSPECTION END
NO
Replace accelerator pedal assembly. Refer to Removal and Installation .