LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 476 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 3)) >> DTC/Circuit Diagnosis >> DTC P1572: Brake Pedal Position Switch >> DTC Description >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If DTC P1572 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to DTC Logic .
  • This self-diagnosis has the one trip detection logic. When malfunction A is detected, DTC is not stored in ECM memory. And in that case, 1st trip DTC and 1st trip freeze frame data are displayed. 1st trip DTC is erased when ignition switch is turned OFF. And even when malfunction A is detected in two consecutive trips, DTC is not stored in ECM memory.

DTC No.

Trouble diagnosis name

(Trouble diagnosis content)

DTC detecting condition

Possible cause

P1572

ASCD BRAKE SW

(Brake pedal position switch)

A)

When the vehicle speed is above 30 km/h (19 MPH), ON signals from the stop lamp switch and the brake pedal position switch are sent to the ECM at the same time.

  • Harness or connectors

    (The stop lamp switch circuit is shorted.)

  • Harness or connectors

    (The brake pedal position switch circuit is shorted.)

  • Stop lamp switch
  • Brake pedal position switch
  • Incorrect stop lamp switch installation
  • Incorrect brake pedal position switch installation
  • ECM

B)

Brake pedal position switch signal is not sent to ECM for extremely long time while the vehicle is being driven.