LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 476 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 3)) >> DTC/Circuit Diagnosis >> DTC P0606: ECM >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE-I 
    1. Turn ignition switch ON (engine stopped) and wait at least 10 seconds.
      CAUTION: Never start engine during this procedure.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Turn ignition switch ON.
    4. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE-II 
    1. Start engine.
    2. Rev up the engine quickly to approximately 3, 000 rpm under unloaded condition and completely release the accelerator pedal.
    3. Let the engine idle and wait at least 10 seconds.
    4. Turn ignition switch OFF and wait at least 10 seconds.
    5. Turn ignition switch ON.
    6. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals