LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 476 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 3)) >> DTC/Circuit Diagnosis >> DTC P050E: Cold Start Control >> DTC Diagnosis Procedure

DTC Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM IDLE AIR VOLUME LEARNING 

    Perform Description .

    Is Idle Air Volume Learning carried out successfully?

    YES

    GO TO 2.

    NO

    Follow the instruction of Idle Air Volume Learning.

  2. CHECK Intake system 

    Check for the cause of intake air volume lacking. Refer to the following.

    • Crushed intake air passage
    • Intake air passage clogging
    • Clogging of throttle body

    Is the inspection result normal?

    YES

    GO TO 3.

    NO

    Repair or replace malfunctioning part

  3. CHECK FUEL INJECTION SYSTEM FUNCTION 

    Perform DTC Confirmation Procedure for DTC P0171, P0174. Refer to DTC Description , DTC Description .

    Is the inspection result normal?

    YES

    GO TO 4.

    NO

    Proceed to DTC Description , DTC Description for DTC P0171, P0174.

  4. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON.
    2. Erase DTC.
    3. Perform DTC Confirmation Procedure.

      See DTC Description .

    Is the 1st trip DTC P050A or P050E displayed again?

    YES

    Replace ECM. Refer to Removal and Installation .

    NO

    INSPECTION END