LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 476 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 3)) >> DTC/Circuit Diagnosis >> DTC P0456: EVAP Control System >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUEL TANK VACUUM RELIEF VALVE 
    1. Turn ignition switch OFF.
    2. Remove fuel filler cap.
    3. Wipe clean valve housing.
      G04073650Courtesy of NISSAN NORTH AMERICA, INC.
    4. Check valve opening pressure and vacuum.
      G04073651Courtesy of NISSAN NORTH AMERICA, INC.

      Pressure:

      15.3 - 20.0 kPa (0.156 - 0.204 kg/cm 2 , 2.22 - 2.90 psi)

      Vacuum:

      -6.0 to -3.3 kPa (-0.061 to -0.034 kg/cm 2 , -0.87 to -0.48 psi)

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    GO TO 2.

  2. REPLACE FUEL FILLER CAP 

    Replace fuel filler cap.

    CAUTION: Use only a genuine fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the MIL may illuminate.

    INSPECTION END