Component Function Check
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK BRAKE PEDAL POSITION SWITCH FUNCTION
With CONSULT
- Turn ignition switch ON.
- Select "BRAKE SW1" in "DATA MONITOR" mode of "ENGINE" using CONSULT.
- Check "BRAKE SW1" indication under the following conditions.
Monitor item
Condition
Indication
BRAKE SW1
Brake pedal
Slightly depressed
OFF
Brake pedal
Fully released
ON
Without CONSULT
- Turn ignition switch ON.
- Check the voltage between ECM harness connector terminals as per the following.
ECM
Condition
Voltage
(Approx.)
Connector
+
-
Terminal
E16
140
152
Brake pedal
Slightly depressed
0 V
Brake pedal
Fully released
Battery voltage
Is the inspection result normal?
YES
INSPECTION END
NO
Proceed to DTC Diagnosis Procedure .