Removal and Installation: Installation

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

When installing brake tube, tighten to the specified torque using a crowfoot and torque wrench so that flare nut and brake tube are not damaged. Refer to Removal and Installation .
Do not remove and install hydraulic booster assembly by holding harness.
Bleed air from brake piping after installation. Refer to Bleeding Brake System .
Do not apply excessive impact to hydraulic booster assembly, such as by dropping it.
Check that connector is fully locked after hydraulic booster assembly harness connector is installed.
Perform yaw rate/side/decel G sensor calibration when hydraulic booster assembly [ABS actuator and electric unit (control unit)] is replaced. Refer to Description .