LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 474 (Brake Control System) >> Symptom Diagnosis >> Vehicle Jerks During VDC/TCS/Abs Control >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. SYMPTOM CHECK 

    Check if the vehicle jerks during VDC/TCS/ABS control.

    Is the inspection result normal?

    YES

    Inspection End.

    NO

    GO TO 2

  2. CHECK SELF DIAGNOSTIC RESULT 

    Perform "Self Diagnostic Result" mode of "ABS". Refer to CONSULT Function (ABS) .

    Are self diagnostic results indicated?

    YES

    Check corresponding items, make repairs, and perform ABS actuator and electric unit (control unit) self diagnostic result again. Refer to CONSULT Function (ABS) .

    NO

    GO TO 3

  3. CHECK CONNECTOR 
    1. Turn ignition switch OFF.
    2. Disconnect ABS actuator and electric unit (control unit) connector.
    3. Check terminals for deformation, disconnection, looseness, etc.
    4. Securely connect connector and perform "Self Diagnostic Result" mode of "ABS". Refer to CONSULT Function (ABS) .

    Are self diagnostic results indicated?

    YES

    If poor contact, damage, open or short circuit of connector terminal is found, repair or replace.

    NO

    GO TO 4

  4. CHECK ECM AND TCM SELF DIAGNOSTIC RESULT 
    1. Perform "Self Diagnostic Result" mode of "ECM". Refer to CONSULT Function (VQ40DE) or CONSULT Function (VK56VD).
    2. Perform "Self Diagnostic Result" mode of "TCM". Refer to CONSULT Function (RE5R05A) or CONSULT Function (RE7R01B).

    Are self diagnostic results indicated?

    YES

    Check the corresponding items.

    NO

    Replace ABS actuator and electric unit (control unit). Refer to Removal and Installation .