Component Description
|
Unit |
Description |
|
|
Combination meter |
Controls the following with the signals received from each unit via CAN communication and the signals from switches and sensors: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
IPDM E/R |
IPDM E/R reads the ON/OFF signals of the oil pressure switch and transmits the oil pressure switch signal to the combination meter via BCM with CAN communication line. |
|
|
Fuel level sensor unit |
Refer to Description . |
|
|
Engine oil pressure sensor |
Transmits the engine oil pressure sensor signal to the ECM. |
|
|
Oil pressure switch |
Refer to DTC Diagnosis Procedure . |
|
|
ECM |
Transmits the following signals to the combination meter with CAN communication line: |
|
|
|
|
|
|
|
|
ABS actuator and electric unit (control unit) |
Transmits the vehicle speed signal to the combination meter with CAN communication line. |
|
|
BCM |
|
|
|
A/T assembly |
|
|
|
Washer fluid level switch (if equipped) |
Transmits the washer fluid level signal to the combination meter. |
|
|
Parking brake switch |
Refer to DTC Diagnosis Procedure . |
|
|
Low tire pressure warning control unit |
Refer to Low Tire Pressure Warning Control Unit . |
|
|
Tow mode switch (if equipped) |
Transmits the tow mode switch signal to the combination meter. |
|
|
Seat belt buckle switch LH/RH |
Transmits the seat belt buckle switch signal to the combination meter. |
|
|
Ambient sensor |
Refer to Component Description (Manual A/C) or Component Description (Auto A/C). |
|