DTC Confirmation Procedure
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "Data Monitor" in "TRANSMISSION".
- Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
ACCELE POSI
: 1.5/8 - 2.0/8
GEAR
: "1"=>"2" (D/C ON/OFF)
SLCT LVR POSI
: "D" position
Driving location
: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
Without CONSULT
- Start the engine.
- Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
Accelerator opening
: 1.5/8 - 2.0/8
Gear position
: "1"=>"2"
Selector lever position
: "D" position
Driving location
: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
- Perform the self-diagnosis.
Is "P1762" detected? / Is "A/T CHECK indicator lamp judgment flicker: 2nd" detected?
YES
Go to Diagnosis Procedure .
NO
Check intermittent incident. Refer to Intermittent Incident .