DTC Confirmation Procedure
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If DTC CONFIRMATION PROCEDURE is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO 2.
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "Data Monitor" in "TRANSMISSION".
- Drive vehicle and maintain the following conditions for at least 2 consecutive seconds.
ENGINE SPEED
: 1, 200 rpm
GEAR
: "1" position
MANU MODE SW
: ON
Is "P1731" detected?
YES
Go to Diagnosis Procedure .
NO
INSPECTION END