DTC Confirmation Procedure

If DTC CONFIRMATION PROCEDURE is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

GO TO 2.

With CONSULT

1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Check ATF temperature is in the following range.

   ATF TEMP 1

   : 20 deg.C (68 deg.F) - 140 deg.C (284 deg.F)

With GST

1. Start the engine.
2. Drive vehicle for approximately 5 minutes in urban areas, GO TO 3.

Is ATF temperature within specified range?

YES

GO TO 3.

NO

Drive vehicle to warm ATF or stop engine to cool ATF.

With CONSULT

1. Select "2ND GR FNCTN P0732" in "DTC & SRT confirmation" in "TRANSMISSION".
2. Drive vehicle and maintain the following conditions.

   MANU MODE SW	: ON
   GEAR	: "2" position
   ACCELE POSI	: 0.6/8 or more
   VEHICLE SPEED	: 10 km/h (6 MPH) or more
   ENGINE SPEED	: INPUT SPEED - 50 rpm or more
   INPUT SPEED	: 300 rpm or more

3. Keep the current driving status for at least 5 consecutive seconds if CONSULT screen changes from "OUT OF CONDITION" to "TESTING".
   CAUTION: When "TESTING" is not indicated on CONSULT for a long time, check "Self Diagnostic Results" mode for "TRANSMISSION". When a DTC other than "P0732" is detected, check the DTC.

   Refer to DTC Index .

With GST

1. Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.

   Manual mode switch	: ON
   Gear position	: "2" position
   Accelerator opening	: 0.6/8 or more
   Vehicle speed	: 10 km/h (6 MPH) or more

2. Check DTC.

Is "STOP VEHICLE" or "COMPLETED RESULT NG" displayed? / Is "P0732" detected?

YES

GO TO 4.

YES

Go to Diagnosis Procedure .

YES

Go to Diagnosis Procedure .

NO

GO TO 4.

1. Stop vehicle.
2. Drive vehicle in "D" position allowing it to shift from 1GR to 5GR and check shift timing and shift shock.

INSPECTION END