LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 471 (Automatic Transmission (Re5R05A) (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC P0711: Transmission Fluid Temperature Sensor A >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always drive vehicle at a safe speed.
  1. PRECONDITIONING 

    If DTC CONFIRMATION PROCEDURE is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

    NO

    GO TO 2.

    NO

    GO TO 3.

  2. CHECK A/T FLUID TEMPERATURE 

    SYMBOL With CONSULT

    1. Turn ignition switch OFF and cool the engine.
    2. Turn ignition switch ON.
      CAUTION: Do not start engine.
    3. Select "ATF TEMP 1" in "Data Monitor" in "TRANSMISSION".
    4. Record A/T fluid temperature.

    A/T fluid temperature is less than 20 deg.C (68 deg.F)

    GO TO 3.

    A/T fluid temperature is 20 deg.C (68 deg.F) or more. (Except for Mexico)

    GO TO 4.

    A/T fluid temperature is 20 deg.C (68 deg.F) or more. (For Mexico)

    INSPECTION END

  3. CHECK DTC DETECTION 

    SYMBOL With CONSULT

    1. Select "SLCT LVR POSI", "VHCL/S SE-A/T", "ACCELE POSI", "ATF TEMP 1" in "Data Monitor" in "TRANSMISSION".
    2. Start the engine and wait for at least 3 minutes.
    3. Drive the vehicle for the total minuets specified in the Driving time column below with the following conditions satisfied.

      SLCT LVR POSI

      : D

      VHCL/S SE-A/T

      : 10 km/h (6 MPH) or more

      ACCELE POSI

      : 0.5/8 or more

      A/T fluid temperature before engine start

      Driving time

      -40 deg.C (-40 deg.F) --31 deg.C (-23.8 deg.F)

      20 minutes or more

      -30 deg.C (-22 deg.F) --21 deg.C (-5.8 deg.F)

      18 minutes or more

      -20 deg.C (-4 deg.F) --11 deg.C (12.2 deg.F)

      14 minutes or more

      -10 deg.C (14 deg.F) --1 deg.C (30.2 deg.F)

      11 minutes or more

      0 deg.C (32 deg.F) - 9 deg.C (48.2 deg.F)

      8 minutes or more

      10 deg.C (50 deg.F) - 19 deg.C (66.2 deg.F)

      5 minutes or more

    SYMBOL With GST

    1. Turn ignition switch OFF and cool the engine.
    2. Start the engine and wait for at least 3 minutes.
    3. Drive the vehicle and maintain the following conditions for 20 minutes or more.

      Selector lever

      : D position

      Vehicle speed

      : 10 km/h (7 MPH) or more

      Accelerator pedal opening

      : 0.5/8 or more
    4. Check the DTC.

    Is "P0711" (With CONSULT) or "P0710" (With GST) detected?

    YES

    Go to DTC Diagnosis Procedure .

    NO

    GO TO 4.

    NO

    INSPECTION END

  4. CHECK A/T FLUID TEMPERATURE SENSOR FUNCTION 

    SYMBOL With CONSULT

    1. Select "ATF TEMP 1" in "Data Monitor" in "TRANSMISSION".
    2. Select "COOLANT TEMP/S" in "Data Monitor" in "ENGINE".
    3. Check temperature difference between A/T fluid and engine coolant.

    SYMBOL With GST

    1. Complete engine diagnoses P0111 and P0116.
    2. After starting the engine start, run the engine at idle for 5 minutes.
    3. Check the DTC.

    Is the temperature calculated by subtracting engine coolant temperature from A/T fluid temperature more than 33 deg.C (91.4 deg.F) or is it less than -19 deg.C (-2.2 deg.F)? (With CONSULT)/Is "P0710" detected? (With GST)

    YES

    Go to DTC Diagnosis Procedure .

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals