Data Monitor
|
Monitor item [Unit] |
Description |
|
|
AMB TEMP SEN |
[°C] |
Ambient sensor value converted from ambient sensor signal received from ambient sensor |
|
IN-VEH TEMP |
[°C] |
In-vehicle sensor value converted from in-vehicle sensor signal received from in-vehicle sensor |
|
INT TEMP SEN |
[°C] |
Intake sensor value converted from intake sensor signal received from intake sensor |
|
SUNLOAD SEN |
[w/m 2 ] |
Sunload sensor value converted from sunload sensor signal received from sunload sensor |
|
AMB SEN CAL |
[°C] |
Ambient sensor value calculated by A/C auto amp. |
|
IN-VEH CAL |
[°C] |
In-vehicle sensor value calculated by A/C auto amp. |
|
INT TEMP CAL |
[°C] |
Intake sensor value calculated by A/C auto amp. |
|
SUNL SEN CAL |
[w/m 2 ] |
Sunload sensor value calculated by A/C auto amp. |
|
COMP REQ SIG |
[On/Off] |
Displays A/C switch ON/OFF status transmitted to other units via CAN communication |
|
FAN REQ SIG |
[On/Off] |
Displays blower switch ON/OFF status transmitted to other units via CAN communication |
|
FAN DUTY |
[%] |
Duty ratio of blower motor judged by A/C auto amp. |
|
XM |
Target discharge air temperature judged by A/C auto amp. according to the temperature setting and the value from each sensor |
|
|
PA TARGET A/TEMP |
Target discharge front air temperature (passenger side) judged by A/C auto amp. depending on the temperature setting and the value from each sensor |
|
|
ENG COOL TEMP |
[°C] |
Water temperature signal value received from ECM via CAN communication |
|
VEHICLE SPEED |
[km/h (mph)] |
Vehicle speed signal value received from meter via CAN communication |