Extended Storage Switch (If Equipped)

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When extended storage switch is pulled out, a message may be shown in the meter or display. To turn message/display off, push extended storage switch in.
The following information is related to extended storage switch (shipping mode). For information related to BCM transit mode, refer to System Description .

The following switch may be mounted on the fuse block (Junction Box) for transportation and storage.

Courtesy of NISSAN NORTH AMERICA, INC.

	Extended storage switch
	Type A		Type B		Type C

Remove the extended storage switch if it interferes when checking fuses.

How/When to turn Extended Storage Switch ON/OFF

CAUTION:

Turn the ignition switch OFF when operating the extended storage switch.
Under normal conditions, keep the extended storage switch in ON state. Never operate the extended storage switch except when necessary.

Type A

Courtesy of NISSAN NORTH AMERICA, INC.
- To turn the extended storage switch OFF, pull out in direction as shown in the figure.
- To turn the extended storage switch ON, press in direction as shown in the figure.
Type B

Courtesy of NISSAN NORTH AMERICA, INC.
- To turn the extended storage switch OFF, pinch tabs of the switch and pull out in direction as shown in the figure.
- To turn the extended storage switch ON, press in direction as shown in the figure.
Type C

Courtesy of NISSAN NORTH AMERICA, INC.
- To turn the extended storage switch OFF, pull out in direction as shown in the figure.
- To turn the extended storage switch ON, press in direction as shown in the figure.

How To Remove Extended Storage Switch

Type A

Turn the ignition switch OFF.
Turn the extended storage switch OFF.
Pinch tabs and tilt to disengage the extended storage switch. Pinch tabs to remove the extended storage switch.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: For bus bar type extended storage switch, never replace bus bar with a fuse, or fuse may continually open.
NOTE:
- Extended storage switch and fuse (or bus bar) are removed together. Remove fuse (or bus bar) from extended storage switch, if necessary.
- Install removed fuse (or bus bar) to fuse block.
- Extended storage switch is for transportation and storage. Reinstallation of switch is not required after removal, but fuse (or bus bar) must be reinstalled/pushed back in to activate all electrical systems and turn message off (which may be shown in meter/display).

Type B

Turn the ignition switch OFF.
Turn the extended storage switch OFF.
Pinch tabs and firmly pull out the extended storage switch in direction.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: For bus bar type extended storage switch, never replace bus bar with a fuse, or fuse may continually open.
NOTE:
- Extended storage switch and fuse (or bus bar) may be removed together. Remove fuse (or bus bar) from extended storage switch, if necessary.
- Install removed fuse (or bus bar) to fuse block.
- Extended storage switch is for transportation and storage. Reinstallation of switch is not required after removal, but fuse (or bus bar) must be reinstalled/pushed back in to activate all electrical systems and turn message off (which may be shown in meter/display).

Type C

Turn the ignition switch OFF.
Turn the extended storage switch OFF.
Pinch tabs and firmly pull out the extended storage switch in direction.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: For bus bar type extended storage switch, never replace bus bar with a fuse, or fuse may continually open.
NOTE:
- Extended storage switch and fuse (or bus bar) are removed together. Remove fuse (or bus bar) from extended storage switch, if necessary.
- Install removed fuse (or bus bar) to fuse block.
- Extended storage switch is for transportation and storage. Reinstallation of switch is not required after removal, but fuse (or bus bar) must be reinstalled/pushed back in to activate all electrical systems and turn message off (which may be shown in meter/display).