Work Procedure
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- SAVE TCM DATA
With CONSULT
Save the TCM data according to the CONSULT display.
NOTE: Even when TCM data is not saved in CONSULT, GO TO 2.GO TO 2.
- REPLACE TRANSMISSION ASSEMBLY
Replace the transmission assembly. Refer to Removal and Installation .
GO TO 3.
- PERFORM TCM PROGRAMMING
- During programming, maintain the following conditions:
Ignition switch
: ON
Selector lever
: P
Engine speed
: 0 rpm
ATF temp.
: 72 deg.C (161 deg.F) or less
- Perform programming according to the CONSULT display.
GO TO 4.
- During programming, maintain the following conditions:
- CONFIRM SHIFT POSITION INDICATOR
- Turn ignition switch ON.
- Shift the selector lever to P position.
- Shift the selector lever to P -> R -> N -> D -> P, confirm the shift position indicator shows correct shift position.
WORK END