Work Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

SAVING TCM DATA
With CONSULT
1. Turn ignition switch ON.
2. Select "Re/programming, Configuration".
3. Select "TRANSMISSION".
  NOTE: If "TRANSMISSION" is not displayed and TCM data cannot be saved on CONSULT, GO TO 2.
4. Select "Programming".
5. Save TCM data on CONSULT according to the CONSULT display.
GO TO 2.
REPLACE CONTROL VALVE WITH TCM
Replace the control valve with TCM. Refer to Removal and Installation .

GO TO 3.
PERFORM TCM PROGRAMMING
With CONSULT
1. Turn ignition switch ON.
2. Select "Re/programming, Configuration".
3. Select "TRANSMISSION".
4. Select "Programming".
5. Perform programming according to the CONSULT display.
GO TO 4.
CONFIRM SHIFT POSITION INDICATOR
1. Turn ignition switch ON.
2. Shift the selector lever to P position.
3. Shift the selector lever to P -> R -> N -> D -> P, confirm the shift position indicator shows correct shift position.
Read TM information in the Service Information and perform necessary learning according to the vehicle, if necessary.