Related To Route Calculation And Visual Guidance

Symptom

Possible cause

Possible solution

Route information is not displayed.

Route calculation has not yet been performed.

Set the destination and perform route calculation.

You are not driving on the suggested route.

Drive on the suggested route.

Route guidance is cancelled.

Turn on the route guidance.

The auto reroute calculation (or detour calculation) suggests the same route as the one previously suggested.

Route calculations took priority conditions into consideration, but the same route was calculated.

This is not a malfunction.

The suggested route is not displayed.

Roads near the destination cannot be calculated.

Reset the destination to a main or ordinary road, and recalculate the route.

The starting point and destination are too close.

Set a more distant destination.

The starting point and destination are too far away.

Divide your trip by selecting one or two intermediate destinations, and perform a global route calculation based on multiple route calculations.

An indirect route is suggested.

If there are restrictions (such as one-way streets) on roads close to the starting point or destination, the system may suggest an indirect route.

Adjust the location of the starting point or destination.

The system may suggest an indirect route because route calculation does not take into consideration some areas such as narrow streets.

Reset the destination to a main or ordinary road, and recalculate the route.

The landmark information does not correspond to the actual information.

This may be caused by insufficient or incorrect data on the map SD-card.

Updated information will be included in the next version of the map SD-card.

The suggested route does not exactly connect to the starting point, waypoints, or destination.

There is no data for route calculation closes to these locations.

Set the starting point, waypoints and destination on a main road, and perform route calculation.