DTC Diagnosis Procedure

When one of the steering wheel audio control switches is pressed, the resistance in steering switch circuit changes depending on which switch is pressed.

1. CHECK STEERING WHEEL AUDIO CONTROL SWITCHES RESISTANCE 
   1. Turn ignition switch OFF.
   2. Disconnect steering wheel audio control switches connector M102.
   3. Check resistance between steering wheel audio control switches connector M102 terminals.

   Combination switch connector M102		Condition	Resistance Ohm (Approx.)
   Terminal	Terminal
   2	5	Depress SOURCE switch.	1
   		Depress switch.	121
   		Depress switch.	321
   		Depress switch.	723
   3		Depress VOL DOWN switch.	1
   		Depress VOL UP switch.	121
   		Depress switch.	321

   Do the steering wheel audio control switches check OK?

   YES

   GO TO 2.

   NO

   Replace steering wheel audio control switch. Refer to Removal and Installation .

2. CHECK HARNESS 
   1. Disconnect AV control unit connector M44 and spiral cable connector M30.
   2. Check continuity between AV control unit harness connector M44 and spiral cable harness connector M30.

      Connector	Terminal	Connector	Terminal	Continuity
      M44	6	M30	24	Yes
      	15		33
      	16		31

   3. Check continuity between AV control unit connector M44 and ground.

      Connector	Terminal	--	Continuity
      M44	6	Ground	No
      	15
      	16

   Are the continuity results as specified?

   YES

   GO TO 3.

   NO

   Repair harness.

3. SPIRAL CABLE CHECK 
   1. Check continuity between spiral cable harness connector M30 and M102.

   Connector	Terminal	Connector	Terminal	Continuity
   M30	24	M102	2	Yes
   	31		3
   	33		5

   Does the spiral cable check OK?

   YES

   Inspection End.

   NO

   Replace spiral cable. Refer to Removal and Installation .