Diagnosis Procedure - Early Production

1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
   • Automatic back door control module
   • CAN gateway (For Mexico)

Is the inspection result normal?

YES

For Mexico: GO TO 2.

YES

Except for Mexico: GO TO 3.

NO

Repair the terminal and connector.

1. Disconnect the connector of CAN gateway.
2. Check the continuity between the CAN gateway harness connector terminals.

   CAN gateway harness connector			Continuity
   Connector No.	Terminal No.
   M5	4	6	Existed
   	10	12	Existed

Is the inspection result normal?

YES

GO TO 3.

NO

Check the harness and repair the root cause (CAN communication circuit 2 side).

1. Connect the connector of CAN gateway. (For Mexico)
2. Disconnect the connector of automatic back door control module.
3. Check the resistance between the automatic back door control module harness connector terminals.

   Automatic back door control module harness connector			Resistance (Ohm)
   Connector No.	Terminal No.
   B55	24	12	Approx. 54 - 66

Is the measurement value within the specification?

YES

GO TO 4.

NO

Replace the body harness.

Check the power supply and the ground circuit of the automatic back door control module. Refer to Diagnosis Procedure .

Is the inspection result normal?

YES

Replace the automatic back door control module. Refer to Removal and Installation .

YES

Error was detected in the automatic back door control module branch line.

NO

Repair the power supply and the ground circuit.