Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect the following harness connectors.
- ECM
- CAN gateway

Check the continuity between the data link connector and the CAN gateway harness connector.

Data link connector		CAN gateway harness connector		Continuity
Connector No.	Terminal No.	Connector No.	Terminal No.
M22	6	M5	1	Existed
	14		7	Existed

Is the inspection result normal?

YES

Check CAN system type decision again.

YES

Error was detected in the main line between the data link connector and the CAN gateway.

Repair the main line between the data link connector and the CAN gateway.