Diagnosis Procedure
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONNECTOR
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Check the terminals and connectors of the ABS actuator and electric unit (control unit) for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal?
YES
GO TO 2.
NO
Repair the terminal and connector.
- CHECK HARNESS FOR OPEN CIRCUIT
- Disconnect the connector of ABS actuator and electric unit (control unit).
- Check the resistance between the ABS actuator and electric unit (control unit) harness connector terminals.
Is the measurement value within the specification?
YES
GO TO 3.
NO
Repair the ABS actuator and electric unit (control unit) branch line.
- CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the ABS actuator and electric unit (control unit). Refer to the following.
- VDC/TCS/ABS TYPE1: Diagnosis Procedure .
- VDC/TCS/ABS TYPE2: Diagnosis Procedure .
NOTE: Check the combination meter type to confirm the service application notice. Refer to Application Notice .Is the inspection result normal?
YES
Replace the ABS actuator and electric unit (control unit). Refer to the following.
- VDC/TCS/ABS TYPE1: Removal and Installation .
- VDC/TCS/ABS TYPE2: Removal and Installation .
YES
Error was detected in the ABS actuator and electric unit (control unit) branch line.
NO
Repair the power supply and the ground circuit.