Component Inspection (Heated Steering Wheel)
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HEATED STEERING WHEEL CONTINUITY
- Turn ignition switch OFF.
- Remove the steering wheel. Refer to Removal and Installation .
- Check continuity between steering wheel connector terminals.
Terminals
Condition
Continuity
1 - 2
Surface temperature of less than 30 deg.C (86 deg.F)
Yes
Surface temperature of 30 deg.C (86 deg.F) or more
No
Is the inspection result normal?
YES
GO TO 2.
NO
Replace heated steering wheel.
- CHECK HEATED STEERING WHEEL RESISTANCE
Check resistance between heated steering wheel connector terminals.
Terminals
Condition
Resistance
1 - 2
Surface temperature of 20 deg.C (68 deg.F)
1.7 - 2.17 Ohm
Is the inspection result normal?
YES
Inspection End.
NO
Replace heated steering wheel.