Work Procedure (Before Replacement)

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECKING TYPE ID (1)
1. Use FAST (service parts catalogue) to search 3CH CAN gateway of the applicable vehicle and find "Type ID".
2. Print out "Type ID".
GO TO 2.
CHECKING TYPE ID (2)
CONSULT Configuration
1. Select "Before Replace ECU" of "Read/Write Configuration".
2. Check that "Type ID" is displayed on the CONSULT screen.
Is "Type ID" displayed?

YES

GO TO 3.

NO

WORK END (Use the "Manual Configuration" after replacing 3CH CAN gateway.)
VERIFYING TYPE ID (1)
CONSULT Configuration

Compare a "Type ID" displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these "Type ID" agree with each other.

NOTE: For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".

GO TO 4.
SAVING TYPE ID
CONSULT Configuration

Save "Type ID" on CONSULT.

WORK END