Work Procedure (After Replacement)

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Use "Manual Configuration" only when "TYPE ID" of CAN gateway cannot be read.
If an error occurs during configuration, start over from the beginning.

CHECKING THAT "TYPE ID" IS SAVED ON CONSULT
Check that "TYPE ID" is saved on CONSULT.

Is "TYPE ID" saved on CONSULT?

YES

GO TO 2.

NO

GO TO 3.
WRITING (AUTOMATIC WRITING)
CONSULT Configuration
1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
2. Select the "Type ID" agreeing with the one stored on CONSULT and the one searched by using FAST (service parts catalogue).
  NOTE: For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".
3. Write the "Type ID" into the 3CH CAN gateway.
GO TO 4.
WRITING (MANUAL WRITING)
CONSULT Configuration
1. Select "Manual Configuration".
2. Select the "Type ID" agreeing with the one stored on CONSULT and the one searched by using FAST (service parts catalogue).
  NOTE: For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".
3. Write the "Type ID" into the 3CH CAN gateway.
GO TO 4.
VERIFYING TYPE ID (2)
Compare "Type ID" written into the 3CH CAN gateway with the one searched by using FAST (service parts catalogue) to check that these "Type ID" agree with each other.

NOTE: For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".

GO TO 5.
PERFORM SELF-DIAGNOSIS RESULT
1. Erase "self-diagnosis result" with CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Perform "All DTC reading" with CONSULT.
Is displayed any DTC for CAN communication circuit?

YES

Repair the CAN communication circuit.

NO

WORK END