Diagnosis Procedure
- CHECK STEP LAMP OUTPUT
CONSULT
- Turn ignition switch ON.
- Select STEP LAMP TEST of BCM (INT LAMP) active test item.
- While operating the test item, check voltage between BCM harness connector M18 terminal 21 and ground.
BCM
Ground
STEP LAMP TEST
Voltage
(Approx.)
Connector
Terminal
M18
21
On
0V
Off
Battery voltage
Is the inspection result normal?
YES
Step lamp control circuit is operating normally.
Fixed ON
GO TO 3.
Fixed OFF
GO TO 2
- CHECK STEP LAMP OPEN CIRCUIT
- Turn ignition switch OFF.
- Disconnect the following harness connectors:
- BCM M18
- Front step lamp LH D11
- Front step lamp RH D109
- Foot lamp LH M99
- Foot lamp RH M100
- Check continuity between BCM harness connector M18 terminal 21 and the following lamp harness connector terminal.
BCM
Step lamp
Continuity
Connector
Terminal
Connector
Terminal
M18
21
Front step lamp LH
D11
2
Yes
Front step lamp RH
D109
Foot lamp LH
M99
Foot lamp RH
M100
Is the inspection result normal?
YES
Check front step lamp or foot lamp for an open. If NG, replace lamp in question. Refer to Removal and Installation (Drive side for foot lamp), Removal and Installation (Passenger side for foot lamp) or Removal and Installation (Front step lamp). If OK, replace BCM. Refer to Removal and Installation .
NO
Repair or replace harness or connectors.
- CHECK STEP LAMP SHORT CIRCUIT
- Turn ignition switch OFF.
- Disconnect the following harness connectors:
- BCM M18
- Front step lamp LH D11
- Front step lamp RH D109
- Foot lamp LH M99
- Foot lamp RH M100
- Check continuity between BCM harness connector M18 terminal 21 and ground.
BCM
Ground
Continuity
Connector
Terminal
M18
21
No
Is the inspection result normal?
YES
Replace BCM. Refer to Removal and Installation .
NO
Repair or replace harness or connectors.